2551 Big Diamond

Panel size
- 2450 x 1050 mm / 96" x 41"
Thickness
- 38mm / 1.50"
Embossment
- one-side
Coreboard
-Plywood
Surfaces
- Oak nature real wood veneer
- Oak smoked real wood veneer
- Oak grey real wood veneer
- Lacquerable foil raw, unlacquered
- Lacquerable foil lacquered in white mat
Delivery
- raw, unlacquered
repeating pattern
Structure
- deep, wide structure

Technical Information

Storage / Transport
Always store in a well-ventilated warehouse, never in areas of high humidity. Always store / transport flat, lying fully on a pallet/board, etc – the corners must never protrude from or overhang the base board of the pallet during storage or transport. Never transport or store the panels upright, either on the short or long side. The cover board should always have at least the same dimensions as the Holz in Form panel, and cover this completely. To avoid contact marks, a layer of corrugated paper/card or foam sheet should be used between the layers. For transport the pallet must be evenly strapped. Before finishing, always allow the panels to settle

Finishing
After being properly stored and transported, and allowed to settle, the panels can be finished using woodworking machines and tools suitable for panel products. Tips on edge finishing can be found on our CD and our website. During finishing it is important to ensure that the panels are kept completely flat and that the corners are not allowed to overhang. Particularly before lacquering, it is important to ensure that the panels are laid completely straight and do not show any distortion, because any distortion (for example, an overhanging corner) will be irreversibly fixed by the lacquering.

Downloads