Prisma
2528 Prisma - play with the geometry.

Panel size
- 1270 x 3135mm
Thickness
- 4,5mm, 18,5mm
Embossment
- 18,5mm einseitig,
- 4,5mm both sides, back side negativ embossed
Coreboard
- 18,5mm Particle board
- 4,5mm MDF
Surfaces
- lacquerable foil raw, unlacquered
- real metall surface (see back side)
- metallic lacquer (see back side)
repeating pattern every100mm
repeating pattern for 1270x3135mm in 1200x3100mm
Structure
- deep, wide structure

Technical information

Storage / Transport
Always store in a well-ventilated warehouse, never in areas of high humidity. Always store / transport flat, lying fully on a pallet/board, etc – the corners must never protrude from or overhang the base board of the pallet during storage or transport. Never transport or store the panels upright, either on the short or long side. The cover board should always have at least the same dimensions as the Holz in Form panel, and cover this completely. To avoid contact marks, a layer of corrugated paper/card or foam sheet should be used between the layers. For transport the pallet must be evenly strapped. Before finishing, always allow the panels to settle

Finishing
After being properly stored and transported, and allowed to settle, the panels can be finished using woodworking machines and tools suitable for panel products. Tips on edge finishing can be found on our CD and our website. During finishing it is important to ensure that the panels are kept completely flat and that the corners are not allowed to overhang. Particularly before lacquering, it is important to ensure that the panels are laid completely straight and do not show any distortion, because any distortion (for example, an overhanging corner) will be irreversibly fixed by the lacquering.

Downloads

Datasheet
Datenblatt-Prisma.pdf

Technical drawings

CAD-Applications

Processing instructions
Kantenberab_GB.pdf